Connecting With Onkyo Ri Components - Onkyo A-9150 Instruction Manual

Connecting with Onkyo RI
Components
By connecting an Onkyo component with
unit by using an
cable, you can link the unit's power and input selection
and enable operation with this unit's remote controller (*).
After connecting the unit and the Onkyo component with
a digital cable or RCA cable (
the following operations.
D/C/B/A
SETUP
1
Connect the
When there are two
same way. You can connect either one.
2
Press SETUP on the remote controller.
SETUP does not work when MAIN IN input is
selected. Select an input other than MAIN IN to
operate.
3
Repeatedly press
When linking with a CD player
1
Select so that D1 and LINE 1 light (or flash).
When linking with a tuner
1
Select so that D2 and LINE 2 light (or flash).
When linking with a
1
audio player
Select so that D3 and LINE 3 light (or flash).
En
26
jack to the
cable and a digital cable or an RCA
to ), perform
page 15 17
CD Player
cable.
jacks, both jacks work in the
D C
/ on the remote controller.
dock or network
B/A
4
Press on the remote controller to select the
jack to use for linking.
The flashing of the input source LEDs changes each
time you change the setting.
When linking with a CD player
1
When connected to the D1 jack, make it so only
the "D1" LED is flashing (the default value is
"D1"). When connected to the LINE 1 jack,
make it so only the "LINE 1" LED is flashing.
When linking with a tuner
1
When connected to the D2 jack, make it so only
the "D2" LED is flashing (the default value is
"D2"). When connected to the LINE 2 jack,
make it so only the "LINE 2" LED is flashing.
When linking with a
1
audio player
When connected to the D3 jack, make it so only
the "D3" LED is flashing (the default value is
"D3"). When connected to the LINE 3 jack,
make it so only the "LINE 3" LED is flashing.
5
Press SETUP on the remote controller.
A connection to the jack is not enough for the units to
operate as a system. The units must also be connect
properly by a digital cable or an RCA cable.
Refer to "Remote Controller" (
of connected devices.
Note
• cables can be connected in any order.
• Some functions may not be supported depending on the
product even when an
• The feature on this unit supports Onkyo CD players,
tuners, network audio players, and
not work properly with other devices such as MD
recorders.
• Only auto-power on and direct change are supported for
CD players.
• Refer to the instruction manual of the component with the
jack for details.
* With (Remote Interactive), you can use the
following special functions:
Auto Power On
∫
When you start playback on a component connected via
while the integrated amplifier is on Standby, the
integrated amplifier will automatically turn on and
select that component as the input source.
Direct Change
∫
When playback is started on a component connected via
, the integrated amplifier automatically selects that
component as the input source.
System Off
∫
When you turn off the integrated amplifier, the
components turn off automatically.
dock or network
) for operation
page 10
connection is used.
docks only. It does