Part Identification Chart - Weslo momentum G 3.2 User Manual

PART IDENTIFICATION CHART

Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the
key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it
has been preassembled. Extra parts may be included.
M8 Locknut
(53)–2
M8 Split
Washer (63)–13
Wave Washer
(73)–2
M8 x 20mm
M4 x 12mm
Screw (54)–3
Screw (66)–6
M8 x 35mm Screw (86)–2
M8 x 65mm Carriage Bolt (51)–2
M8 Acorn Nut M10 Locknut
(58)–6
M8 Curved
Washer (101)–2
M10 Washer
(92)–8
M8 x 20mm Hex
Screw (57)–2
M8 x 40mm Bolt (56)–4
M10 x 70mm Bolt (60)–2
Left Crank
Locknut (37)–1
(93)–6
M8 Washer
M8 Large
(55)–14
Washer (72)–2
M10 Plastic
Washer (62)–4
M8 x 65mm Bolt (100)–2
6
Right Crank
Locknut (36)–1
M8 Plastic
Washer (27)–2
M12 Split
Washer (74)–2
M8 x 60mm
Bolt (90)–2
M10 x 45mm Bolt (91)–4