Static Table.
This section describes how to configure the Static IP Source Guard Table parameters of the switch. These can be used to
configure and manage the entries.
To configure a Static IP Source Guard Table in the web interface:
•
Click Configuration / Security / Network / IP Source Guard / Static Table
•
Click Add new Entry
•
Specify the Port, VLAN ID, IP Address, and MAC address in the entry.
•
Click Apply and click the Save icon in the upper right corner to save the settings or click Reset to cancel. The
Form will return to the previously saved settings.
Access Control List Configuration Parameters:
Items
Delete
Port
VLAN ID
IP address
Mac Address
Adding new entry
ARP Inspection
This section describes how to configure the ARP Inspection parameters of the switch and can be used to configure and
manage the ARP table.
To configure the ARP Inspection in the web interface:
•
Click Configuration / Security / Network / ARP Inspection / Port Configuration
•
Select Enabled in the Mode field.
•
Select Enabled for the specific port.
•
Click Apply and click the Save icon in the upper right corner to save the settings or click Reset to cancel. The
Form will return to the previously saved settings.
Description
Check to delete the entry. It will be deleted during the next save.
The logical port for the settings.
The VLAN id for the settings.
Allowed Source MAC address.
Allowed Source MAC address.
Click to add a new entry to the Static IP Source Guard table. Specify the Port, VLAN ID, IP
address, and IP Mask for the new entry. Click "Save".
59