Dhcp Server Excluded Ip - i3 International Cortex S243 User Manual

DHCP Server Mode Parameters:
Items
Mode
VLAN Range
Mode

DHCP Server Excluded IP

This page configures excluded IP addresses. The DHCP server will not allocate these excluded IP addresses to DHCP
clients.
To configure the DHCP Server Excluded IP in the web interface:

Click Configuration / DHCP / Server/ Excluded IP

Click Add IP Range then create new IP Range on the switch.

Click Apply and click the Save icon in the upper right corner to save the settings or click Reset to cancel. The
Form will return to the previously saved settings.
DHCP Server Excluded IP Parameters:
Items
IP Range
Description
Configure the operation mode per system. Possible modes are:
Enabled: Enable DHCP server per System.
Disabled: Disable DHCP server per System.
Indicate the VLAN range in which DHCP server is enabled or disabled. The first VLAN ID
must be smaller than or equal to the second VLAN ID. BUT, if the VLAN range contains only 1
VLAN ID, then it can be input into either one of the first and second VLAN ID or both.
However, to disable existing VLAN ranges follow these steps:
1. Click "ADD VLAN Range" to add a new VLAN range.
2. Input the VLAN range that you want to disable.
3. Choose Mode to be disabled.
4. PressApply to apply the change.
Then the disabled VLAN range is removed from the DHCP Server Mode configuration page.
Configure the operation mode per VLAN. Possible modes are:
Enabled: Enable DHCP server per VLAN.
Disabled: Disable DHCP server per VLAN.
Description
Define the IP range to be excluded IP addresses. The first excluded IP must be smaller than
or equal to the second excluded IP. BUT, if the IP range contains only 1 excluded IP, then it
can be entered into either one of the first or second excluded IP boxes or both.
28