i3 International Cortex S243 User Manual page 123

MAC: Match specific DMAC.
The default value is Any
SMAC Match specific source MAC address or 'Any'. If a port is configured to match on DMAC/DIP, this field
indicates the DMAC.
Tag Indicates the tag type. Possible values are:
Any: Match tagged and untagged Frames.
Untagged: Match untagged Frames
Tagged: Match tagged Frames.
C-Tagged: Match C-Tagged Frames
S-Tagged: Match S-Tagged frames.
The default value is 'Any".
VID Indicates the VLAN ID, either a specific VID or range of VIDs can be in the range of 1-4095 or 'Any'.
PCP Priority Code Point. Valid values of PCP are specific (0, 1, 2, 3, 4, 5, 6, 7) or range (0-1, 2-3, 4-5, 6-7, 0-
3, 4-7) or 'Any'.
DEI Drop Eligible indicator. Valid value of DEI are 0,1 or 'Any'.
Frame Type Indicates the type of frame to look for incoming frames. Possible frame types are:
Any: The QCE will match all frame types.
Ethernet: Only Ethernet frames with Ether Type 0x600-OxFFFF are allowed.
LLC: Only LLC frames are allowed.
Snap: Only SNAP frames are allowed.
IPv4: The QCE will match only IPv4 frames.
IPv6: The QCE will match only IPv6 frames.
Action Indicates the classification action taken on ingress frame if parameters configured are matched with
Modification the frame's content.There are three action fields:
Buttons
Class: Classified QoS Class; if a frame matches the QCE it will be put in the queue.
Port Members
DPL: Drop Precedence Level; if a frame matches the QCE then DP level will set to value displayed
Key Parameters
under DPL column.
DSCP: If a frame matches the QCE then DSCP will be classified with the value displayed under DSCP
column.
Each QCE can be modified using the following buttons
: Inserts a new QCE before the current row.
: Edits the QCE.
&
: Deletes the QCE.
: The lowest plus sign adds a new entry at the bottom of the QCE listings.
Check the checkbox button to made any port member of the QCL entry By default all ports will be
checked.
Key configuration are described as below:
Tag Value of Tag field ccna be 'Any', 'Untag' or 'Tag'
VID Valid value of VLAN ID can be any value in the range 1-ro95 or 'Any' user can enter either a specific
value or a range of VIDs.
PCP Priority Code Point: Valid value PCP are specific (0, 1, 2, 3, 4, 5, 6, 7, ) or range (0-1, 2-3, 4-5, 6-7,
0-3, 4-7, ) or 'Any'.
DEI Drop Eligible Indicator: Valid value of DEI can be 0, 1, or 'Any'
SMAC Source MAC address: 24 MS bits (OUI or 'Any').
DMAC Type Destination MAC Type: Possible vaules are unicast (UC), multicast (MC), broadcast (BC) or
'Any'.
Frame Type: This can have any of the following values
1.
2.
moves the QCE up or down the list.
Any: Allows all types of frames.
Ethernet: Valid Ethernet type can have a value within 0x6000-OxFFFF or 'Any', default value
is 'Any'
122