Setting Prefix And/Or Suffix Characters (Preamble/Postamble) - PSC SP400 Manual

S P
ETTING REFIX AND
To set the prefix or suffix, identify your specific system requirements for
modification of the settings, then follow these steps:
1. Look at the ASCII chart on the inside back cover of this
manual and identify the ASCII character and the correspond-
ing Hex Code you will use as the prefix or suffix.
2. Scan the SET label below.
3. Scan either the SET PREFIX or SET SUFFIX label.
4. Scan the Hex Code for that character.
(e.g. 03, 8F, ...FF)
If you make a mistake, or lose your place while setting this option,
scan the END label to exit Programming Mode. The scanner will
sound an error tone to indicate that programming was incom-
plete, and the setting will remain as it was before entering
Programming Mode.
5. If setting a single character, scan the ONE CHARACTER ONLY
label on the second page following.
6. Scan the END label.
You have set the prefix or suffix.
SET -------------------------------------
S
ET
S
ET
R44-1542
/ S
OR UFFIX
P -------------------
REFIX
S -------------------
UFFIX
C (P
HARACTERS
NOTE
/P
REAMBLE OSTAMBLE
)
1 1