Table of Contents
Advertisement
If you only want a single character identifier, follow this modified proce-
dure for setting label identifier.
1. Look at the ASCII chart shown on the inside back cover of
this manual and identify the ASCII character and the corre-
sponding Hex Code for the ASCII character you will use as
the symbology specific identifier.
2. Scan the SET label on page 15.
3. Scan the appropriate label for setting either TRANSMIT LABEL
I.D. AS PREFIX or SUFFIX.
4. Scan the label identifier label from pages 16-17 for the
symbology identifier that you are going to change.
As an example, assume that you want to change the label
identifier for EAN-8 from the default setting FF to the ASCII
value 8. Scan the Set Symbology Specific Label Identifier
bar code for EAN-8.
5. Identify the hex value that correspond to the ASCII character.
In this example '8' equals 38
Simply follow the hex value for '8' (38
Character Only label. This tells the scanner that '8' is a
single character label identifier.
6. Scan the bar code values.
For the example in step five, scan 3, 8, One Character Only
on the following two pages.
If you make a mistake, or lose your place while setting this option,
scan the END label to exit Programming Mode. The scanner will
sound an error tone to indicate that programming was incom-
plete, and the setting will remain as it was before entering
Programming Mode.
7. Scan the END label.
You have changed the default label identifier for EAN-8
from 'FF' to '8'.
1 8
SP400/QuickScan 6000/6000 Plus Keyboard Wedge I/F Prog
H
S
S
OW TO
ET
INGLE
C
L
HARACTER
ABEL
.
hex
) with the One
hex
NOTE
I.D.
Advertisement
Table of Contents
