Table of Contents
Advertisement
3
Details of Servicing and Troubleshooting
3-1 Details of Servicing
3-1-1 Removing Disc from Faulty Recorder
If disc cannot be removed due to fault, disassemble the recorder and remove the disc by the
following procedure:
1) Remove the top cover.
[See 4-2 (1) for removal procedure.]
2) Remove the front panel.
[See 4-2 (2) for removal procedure.]
3) Use a screwdriver, etc. to move the cam slider
at the right of DVD Multi drive in the direction
of arrow A: The disc tray will slightly come
forward.
Pull out the disc tray in the direction of arrow
B. Take great care during this work so as not to
damage the disc.
3-1-2 Removing Video Cassette from Faulty Recorder
If video cassette cannot be removed due to fault, disassemble the recorder and remove the video
cassette by the following procedure:
1) Remove the top cover. [See 4-2 (1) for removal procedure.]
2) Remove the front panel. [See 4-2 (2) for removal procedure.]
3) Remove the setscrew, and then release the gear of loading motor.
4) Turn the gear worm wheel in the direction of arrow A: Unloading will start. When the tape starts
to slacken, turn the holder clutch on the front of deck mechanism to remove slack in tape. (The
holder clutch can also be turned through the hole in bottom frame.)
5) When unloading is complete, the VCR will enter the eject operation: Fully turn the gear worm
wheel in the direction of arrow A until it stops.
"A"
Remove screw
GEAR WORM WHEEL
UNLOADING/
EJECT
Fig. 3-1-2 Removing Video Cassette
TRAY DISC
"B"
SCREWDRIVER
Fig. 3-1-1 Removing Disc
HOLDER CLUTCH
"B"
Removing slack in tape
3 - 1
SLIDER CAM
"A"
Advertisement
Table of Contents
