Philips Hudson2 200P3 Service Manual page 23

The display of SERIAL NO. by OSD can be change/update by
another application software only.
Analog Mode and Digital Mode are using same EEPROM(pos. 7463)
for display of SERIAL NO. by OSD" as shown in Fig. 1.
PRODUCT INFORMATION
------->
SERIAL NO:
RESOLUTION: 1024 X 768 / 75Hz
VIDEO INPUT:
BACK TO MAIN CONTROLS
OK
Fig. 1 (example, SERIAL NUMBER by OSD)
*****************************************************************************
Change/update the serial number which should be proceed
by application software "SerialNumber.exe" as shown in Fig. 2..
*****************************************************************************
Connection: for Serial Number application
25 pins 9 pins
Remove
plastic cover-->
Step 1: Double click "SerialNumber.exe"
Bring up: Fig. 4
Serial number application
TY 123456
ANALOG(D-SUB)
Fig. 2
Monitor
PC
Rear view of 200P3
Com1 or
Com2
Connect to
Mains cord
9 pins
Video cable
Fig. 3
Fig. 4
Fill out serial number of monitor.
For example "TY 876543" as shown in Fig. 5.
Fig. 5
Step 2: Click "Serial Number" as shown in Fig. 6.
Fig. 6
Bring up Fig. 7 with "57600,n,8,1 Com1"
D-Sub
Fig. 7
Step 3: Verify "Serial Number" by OSD as shown in Fig. 8,9.
Press OK button
=>select "PRODUCT INFORMATION"
=>press OK button
Bring up :
Fig. 9 for verification.
Hudson2 200P3
Go to cover page
(two space)
(click "Serial Number")
(Com port for application)
Fig. 8
PRODUCT INFORMATION
---------->
SERIAL NO:
RESOLUTION: 1024 X 768 / 75Hz
VIDEO INPUT:
Fig. 9
BACK TO MAIN CONTROLS
OK
23
TY 876543
ANALOG(D-SUB)