Philips Hudson2 200P3 Service Manual page 20

20
Hudson2 200P3
Go to cover page
Fig. 38
Click Finish to exit the Step window as shown in Fig. 39.
Step 6: Write DDC data
1. Click (Write EDID) icon from the tool bar to write DDC data.
2. Click (Read EDID) to re-confirm (check contents) it.
The 128bytes DDC data which had been written into DDC IC of
Digital Mode.
Step 7: Save DDC data
Sometimes, you may need to save DDC data as a text file for using
in other IC chip. To save DDC data, follow the steps below:
1. Click (Save) icon (or click "file"-> "save as") from the tool bar
and give a file name as shown in Fig. 40.
2. Click Save .
Step 8: Load DDC data
1. Click from the tool bar.
2. Select the file you want to open as shown in Fig 41.
3. Click Open .
Step 9: Exit DDC program
Pull down the File menu and select Exit as shown in Fig. 25.
DDC Instructions (Continued)
The display of SERIAL NO. by OSD can be change/update by
Analog Mode only.
It means "Analog Mode and Digital Mode are using same EEPROM
for display of SERIAL NO. by OSD" as shown in Fig. 42.
Fig. 39
Fig. 40
Fig. 41
PRODUCT INFORMATION
------->
SERIAL NO: TY 123456
RESOLUTION: 1024 X 768 / 75Hz
VIDEO INPUT: ANALOG(D-SUB)
BACK TO MAIN CONTROLS
OK
************************************************************************
Change/update the serial number which should be proceed
by another application software.
************************************************************************
Fig. 42