Advertisement
R
epair
[4] DISASSEMBLY/ ASSEMBLY
[4]-7. Clutch drum complete (cont.)
ASSEMBLING
(1) After putting Retaining ring R-35 on the center of Clutch drum complete, pressfit Ball bearing 6003LLU in place of
Clutch drum complete with 1R028. (Fig. 23)
Fit Retaining ring S-17 into the groove of Clutch drum complete with 1R004. (See Fig. 21)
(2) Assemble Shaft complete with Damper to Clutch drum complete so as to mate the connecting portions of Shaft
complete and Clutch drum complete in Damper. (Fig. 24)
Assemble the assembled part to Clutch case complete by tapping the center of Clutch drum complete carefully with
Plastic hammer. (Fig. 25)
(3) Fit Retaining ring R-35 into the groove of Clutch case complete with 1R006 through the hole of Clutch drum complete,
then set M6x14 Hex bolt and Flat washer 6 on Clutch drum complete while inserting Hex wrench into Gear case
assembly and pretighten Receive washer and Clamp washer with M10 Nut to prevent the rotation of Shaft complete.
(See Figs. 18 and 17)
Note: Apply ThreeBond 1342/ Loctite 242 to the thread of M6x14 Hex bolt.
Fig. 23
Retaining ring R-35
1R028
Ball bearing
6003LLU
Clutch drum complete
Fig. 24
Ball bearing 6003LLU
Damper
Fig. 25
Clutch drum complete
Plastic hammer
Retaining ring R-35
Retaining ring S-17
Connecting portion of Clutch drum
complete
Connecting portion of
Shaft complete
Clutch case complete
P 7/ 15
Advertisement
