Specifications; An Important Word About Power Levels; Important Safety Warning - LDG Z-100Plus Operation Manual

SPECIFICATIONS

0.1 to 125 watts SSB, CW, and digital modes.
Latching relays for ultra-low power operation.
2,000 memories for instantaneous frequency and band changing.
7 to 18 Volts DC, 100 mA. Virtually zero current when not tuning.
Optionally internal battery powered, 7-18VDC
1.8 to 54.0 MHz continuous frequency coverage. Frequency for memory storage is
determined by internal frequency counter.
Tunes 6 to 800 ohm loads (16 to 150 on 6M), 16 to 3200 ohms with optional 4:1 Balun.
For Dipoles, Verticals, Vees, Beams or any Coax Fed Antenna.
Optional external Balun allows tuning of random length, long wire or ladder line fed
antennas.
Dimensions: 5"L x 5"W x 1.5"H.
Weight: 1.0 pounds

AN IMPORTANT WORD ABOUT POWER LEVELS

The Z-100Plus is rated at 125 watts maximum power input at most. Many ham transmitters and
transceivers, and virtually all amplifiers, output well over 125 watts. Power levels that significantly
exceed specifications will definitely damage or destroy your Z-100Plus. If your tuner fails during
overload, it could also damage your transmitter or transceiver. Be sure to observe the specified
power limitations.

IMPORTANT SAFETY WARNING

Never install antennas or transmission lines over or near power lines. You can be seriously
injured or killed if any part of the antenna, support or transmission line touches a power
line. Always follow this antenna safety rule: the distance to the nearest power line should be
at least twice the length of the longest antenna, transmission line or support dimension.
PAGE 4