Removing A Ceiling Flush Mount Bracket (Optional Wb-S575) - JVC TK-C655 Instructions Manual

Others

Removing a Ceiling Flush Mount Bracket (Optional WB-S575)

3.
4.
Stoppers
5.
Push the stopper release lever
Release
upwards with a screwdriver, etc.
label
6.
44
<Check the release labels thoroughly before removal.>
1.
Remove the ceiling panel.
Pull the ceiling panel and disengage the two hooks.
2.
Remove the camera.
Remove the camera from the Ceiling Mount by reversing the at-
taching procedure.
☞
Clamping
bracket
3.
Loosen the clamping screws of the Ceiling Flush
Mount Bracket.
• Loosen the three clamping screws (by turning them counterclock-
• Make sure that the clamping brackets move inwards.
4.
Lower the Ceiling Flush Mount Bracket until the
stoppers contact the ceiling plate.
*
5.
Push up the stopper release lever, marked (
figure, using a screwdriver.
• While holding the Ceiling Flush Mount Bracket from below so that
• If the ceiling plate is thick and the stoppers cannot be released
6.
Pull out the Ceiling Flush Mount Bracket from the
hole in the ceiling.
Tilt the Ceiling Flush Mount Bracket and move it obliquely down-
ward to remove it.
P. 18, "Attaching the Camera"
wise).
it does not drop, push up the one of the three stopper release
levers marked ( )using a screwdriver or a similar tool.
*
easily, push up two of the stopper release levers (including the
one marked ( )).
*
) in the
*