AirStage UTY-LNHY Installation Manual page 6

(17) Press the " " or the " " buttons to adjust the address data. The
refrigerant circuit address range is between 00 and 99. Each time the
"MODE" button is pressed, it switches between the one's place and
the ten's place.
Range
00 - 99
(18) Press the "START/STOP"
button once to send the
information. A beeping
sound will be heard if the
command is accepted.
* In the following cases the setting signal is not read and a buzzer
sounds. The setting of the rotary switch on the PC board is not "00"
: Pi Pi Pi Pi Pi
(19) Indoor unit will display the refrigerant circuit address data number on
"TIMER " (ORANGE) and "FILTER
1 sec ON Flashing times of
1 sec OFF address numbers
(the ten's place)
(Example) ADDRESS : 25
OPERATION LAMP
(GREEN)
0.5sec ON / 0.5sec OFF
TIMER LAMP
(ORANGE)
2 times
0.5sec ON / 0.5sec OFF
FILTER LAMP
(RED)
5 times
* ADDRESS 0 setting will not indicate TIMER LAMP and
FILTER LAMP.
Confi rmation of address setting
(20) Press the "TIMER set (+)" button.
"TIMER set (+)"
CORRECT :
En-5
UP
DOWN
" (RED) light.
Flashing times of
address numbers
(the one's place)
1sec ON / 1sec OFF
1 - 10 sec
1 - 10 sec
PiPi
Pi PiPiPiPiPi
PiPi
WRONG : Pi (3 sec)
■ Completion of address setting mode
(21) Press and hold the "MANUAL/AUTO" button for 3 seconds.
IR RECEIVER
UNIT
* Each LED light brightness is darkening though the content of the display
doesn't change.
(22) Press the "RESET" button.
After pressing the "RESET" button,
please set the custom code again if b,c,d
setting.
* The address setting signal is not received after switched
address setting completion mode. (Pi Pi Pi Pi Pi)
* Press the "MANUAL/AUTO" button again for 3 sec to return to if required
to return the address setting mode.
■
Reconfi rmation of address setting
(23) Press and hold the "FAN" and the "SET TEMP.
buttons. Whilst holding these 2 buttons, press the "RESET" button.
FAN
SET TEMP. ( )
RESET
Indoor unit address setting
(24) Make sure the
function number is
"01". Refer to (8).
Press the "TIMER
"TIMER set (-)"
set (-)" button.
(Example) ADDRESS : 34
OPERATION LAMP
(GREEN)
TIMER LAMP
(ORANGE)
3 times
0.5sec ON / 0.5sec OFF
FILTER LAMP
(RED)
4 times
MANUAL AUTO
"
Address setting
mode display
0.5sec ON / 0.5sec OFF
1 - 10 sec
1 - 10 sec
RESET