Samsung WB09H7 Series User Manual page 13

Step 3 - Connect the water supply hoses
CAUTION
• Before installing the water supply hoses, make sure
there are rubber gaskets (A) inside the fittings at both
ends of each new water hose. Installingthe water
supply hoses without rubber gaskets may cause water
leakage.
When installing the washer for the first time, make sure
to use new hoses. Failingto do so may result in a water
leakage or overflow and may cause property damage.
Do not connect water supply hosestogether to
increasethe length of the supply hose. Hoses
connected this way may leak resultingin electrical
shock. If a hose is too short, replacethe hose with a
longer, high pressure hose.
i, /)
\
1,
2.
Connect the ends of the water supply hoses to the hot and _ ".
cold water taps.
Tightenthe fittings by hand until they are snug, and then
tighten them an additional two-thirds turn with a wrench.
Make sure the hoses are firmly connected by gently pulling
them downwards.
3°
4°
Run water into a bucket for a few seconds to clear the water
lines. Close the water taps before continuing.
Connect the hot-water supply hose to the hot-water supply
intake at the back of the washer. Connect the cold-water
supply hose to the cold-water supply intake at the back of the
washer.
\.
English o 13