Wall Mounting; Tone/Pulse Switch; Telephone Setup - Bell Sonecor Equipment BE-3872 Installation And Operating Manual

TELEPHONE SETUP

Wall Mounting

The BE-3872 telephone may be installed onto two screws (not included)
fastened into the wall. When installing screws into plasterboard walls, use wall
anchors (not included) to ensure that the screws remain secure. Insert the
screws into the wall leaving 3/16" of each screw extending out from the wall.
See the wall mount template on page 37 to properly space the screws in the
wall for mounting. The BE-3872 is not compatible with mounting on a standard
telephone wall plate.
Wall Mounting Instructions:
1. Remove the handset from the
base.
2. Adjust the base to the wall mount
position (see illustration).
3. Plug the supplied 7-foot telephone
cord into the Line jack on the
telephone.
4. Connect the telephone line cord
to the wall jack.
5. Insert the AC adapter into the 9V
DC jack on the top of the base.
6. Run the cables down through the
cable channel to allow for flush
wall mounting.
7. Slip the telephone base onto the
wall, lining up the wall mounting holes over the screws. Slide the telephone
base down so it is firmly in place.
8. Return the handset to the telephone base.
9. Plug the other end of the AC adapter into the AC outlet.
15
TELEPHONE SETUP

Tone/Pulse Switch

RINGON /RINGOFF
ICM/ANNC
TONE /PULSE
Tone/Pulse
Switch
Tip: If you are unsure of the proper dialing mode, make a trial call with the dial
mode setting to TONE. If the call connects, leave the switch as is (TONE
mode), otherwise, set to PULSE.
NOTE: Pulse dialing works for direct dialing and redialing only, not for memory
dialing.
Handset Volume
Adjust the receiver volume of the handset using the
volume control switch on the right side of the
handset.
1. Choose the correct dialing mode.
2. Select the dialing mode Tone or
Pulse by setting the switch on the
bottom of the base unit.
Note: Changes to the switch position
during a call do not take effect
until the call has ended.
16