Location Of Controls And Features; Handset - Bell Sonecor Equipment BE-3872 Installation And Operating Manual

LOCATION OF CONTROLS AND FEATURES

Handset

2.4
1.
2.
In Use/
Low Batt.
3.
4.
5.
MEM Pause
7
GHz
6.
7.
8.
9.
10.
11.
12.
13.
LOCATION OF CONTROLS AND FEATURES
1. Volume Switch
The RINGER switch is used to adjust the handset receiver volume level
between Hi (High), Med (Medium) and Low.
2. In Use LED
On (red) when line is in use. Flashes when the battery is low.
3. Talk T
The T key is used to access the telephone line or end a call.
4. Temporary Tone key *
If the base is set to pulse dialing, pressing * causes subsequent digits to be
dialed out using tone until the line is put back on hook.
5. Memory Key l
Use l to program and retrieve the numbers in the speed dial directory.
6. Channel Key c
The c key, if pressed when the line is off-hook, will scan up to 50 chan-
nels and select the clearest one to provide the best possible reception.
7. Flash Key E
The E key is used to access telephone company services, such as call
waiting.
8. Headset Jack
Allows using a standard 2.5mm headset for hands-free convenience.
9. Dial Pad
Numeric keys are used in the conventional manner for dialing.
10. Redial Key R
When the phone is idle or off-hook, press R to redial the last number
dialed.
11. Pause Key
Pause
is used to insert a 4-second pause into a stored number.
Pause
12. Ringer Switch
The RINGER switch is used to adjust the handset ringer level between Hi, Low,
and Off.
13. Microphone
8