Battery Installation; Battery Duration; When The Battery Needs Charging; When To Purchase A New Battery Pack - Bell Sonecor Equipment BE-3872 Installation And Operating Manual

BATTERY INSTALLATION

To install the 3.6V 600mAh cordless handset battery pack:
1. Slide open the battery compartment door on the back
of the handset.
2. Insert the battery into the battery compartment and
then plug the battery connector into the 2-pin
connector located just inside the battery compartment.
3. Close the battery compartment door.
4. Place the handset on the base unit cradle.
5. Once you have installed the battery pack and placed
the handset on the base you will hear a tone indicating
the handset has connected with the base and will
successfully charge.
6. IMPORTANT: Charge the battery pack for at least 12
hours before using the handset the first time.
7. The CHARGE LED on the base illuminates when the
handset is properly making contact with the charge
terminals.

Battery Duration

A fully charged battery lasts for approximately:
• 5 hours when you use the handset continuously (talk
time).
• 5 days when the handset is not in use (standby).

When the Battery Needs Charging

• The phone will beep.
• The In Use/Low Batt LED will flash.

When to Purchase a New Battery Pack

If the battery lasts only a few minutes even after a full charge, the usable life of
the battery has expired and needs to be replaced. Replacement batteries can
be purchase directly from https://www.ttsystems.com/ShoppingCart/shop.asp,
or you can contact TT Systems LLC customer support center at 1-800-592-1336
for information about how to order a new battery.
17

HEADSET AND DATA JACK

Data Jack

The Headset Jack

The headset jack is located on the side of the
handset and is a standard 2.5mm plug. Simply
plug the headset (not included) into the jack and
the headset will be active.
Note: When the headset is plugged into the
telephone, the microphone and earpiece on
the handset are not active.

Belt-clip

Belt-Clip
Be sure to remove the belt-clip filler cap prior to installing the
belt-clip. Install the belt-clip as shown.
To remove the belt-clip, squeeze the release at the top of the
clip where it attaches to the phone, and gently pull the clip up
and out of the handset.

The Data Jack

The jack located on the side of the
telephone labeled "DATA" is a
convenience jack. It is useful for
connecting a fax machine or modem
when there is no telephone jack avail-
able for that device.
Headset Jack
18