Basic Operation; Making Calls; Receiving Calls; Additional Options - Bell Sonecor Equipment BE-3872 Installation And Operating Manual

2.4ghz cordless digital answering system
Hide thumbs Also See for BE-3872:
Table of Contents

Advertisement

BASIC OPERATION

Making Calls

1. Pick up the handset from the base and press T.
The LED on the handset will glow steadily when a
connection is made. Wait until you hear a dial tone.
2. Dial the number you wish to dial.
3. When you are finished talking, press the T key or
place the unit back into the base to end the call.
Note: The IN USE light on the handset will flash when
the line is active.

Receiving Calls

Make sure that the handset ringer switch is not set to
"Off" in order to receive incoming calls.
When you hear the phone ring:
1. If the handset is in the base, lift the handset from the base. The handset will
turn on. There is no need to push the T key if the unit is on the base when
the call comes in.
2. If the handset is off the base, you will need to press T to answer the call.
3. When you are finished, push T or place the handset back on the base.

Additional Options

To:
Do This:
Press T. Wait for dial tone and then press R.
Redial the last number
Adjust the volume in the
Adjust the Volume Hi/Mid/Low switch on the upper left
earpiece
side of the handset, until the desired volume is reached.
Press the * key after the phone is in use. The phone
Switch to temporary tone
dialing
will remain in tone dialing mode for the duration of the call.
Press E to go to the new caller.
Receive a call waiting call
Press E again to go back to the original caller.
Flash Key
In Use LED
In Use/
Low Batt.
Talk Key
Temporary
Tone Key
MEM
Pause Key
19
The BE-3872 will store up to 10 speed dial numbers.

Storing Phone Numbers

1. With the handset in the idle state, press l.
The handset will beep.
2.4
GHz
2. Dial the number you wish to store (up to 16 digits).
Note: Press R/PAUSE to insert a dialing pause
into the number. The pause lasts for 4 seconds
and uses one digit of the 16 digits available.
3. Press l.
4. Press the dial pad key (0-9) for the location where
you wish to store the number. The handset will give
Pause
a confirmation tone.
Note: If you make a mistake the handset will give
Redial Key
three quick beeps to let you know that the
number was not stored.

Making Speed Dial Calls

1. Push T. The handset In Use LED will glow steadily when a connection is
made. Wait until you hear a dial tone.
2. Press l and the dial pad key location where the number is stored.
3. When you are finished with your call, press T, or place the handset back
on the base.
Note: Be sure to check that the line is not in use by another extension.

Deleting a Stored Number

1. With the handset in the idle state, press l. The handset will beep.
2. Press R and then press l. After each press the phone will beep.
3. Press the dial pad key location where the stored number that you want to
delete is located. The handset will give a confirmation tone.

SPEED DIALING

In Use LED
Talk Key
Memory Key
20
2.4
GHz
In Use/
Low Batt.
MEM
Pause
Redial Key

Advertisement

Table of Contents
loading

Related Products for Bell Sonecor Equipment BE-3872

Table of Contents