Finishing; Cast Front Removal; Log Placement - Napoleon GVFS60P Installation And Operating Instructions Manual

12

3.0 FINISHING

3.1

CAST FRONT REMOVAL

FRONT / SCREEN MUST BE IN PLACE WHILE THE APPLIANCE IS IN OPERATION.
3.1.1 Lift the top casting off the
unit.
3.1.3 Loosen the securing bolts
on the cast front off of each
of the respective retainer
brackets (located at either
side on the top). Lift the
front casting off and place
the cast front face down on
a protective surface such
as a carpet or blanket to
avoid scratching the fi nished
surface.
3.1.4 To re-install the front, repeat
in reverse order and ensure
bottom locating tabs engage on either leg.
3.2

LOG PLACEMENT

Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally
Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition. PHAZER
logs glow when exposed to direct fl ame and provide a unique and realistic glowing effect. Use only certifi ed
PHAZER TM logs available from your Napoleon dealer.
Place log #1 onto the burner, centering it onto the
burner tray and pushing it as close to the rear wall of
the fi rebox as possible. Move logs #2 and #3 into
position, lining up the studs located on the burner
with the holes on the bottom of the logs. Sit the notch
at the bottom of log #4 against the left outermost
grate post and position the top of the log into the
pocket provided on the rear log (#1).
W415-0796 / 05.15.09
approved with this heater may result in property damage or personal injury.
WARNING
!
CAST FRONT
SECURING BOLTS
SCREEN
SECURING BOLTS
BOTTOM
LOCATING TABS
WARNING
!
FIGURE 3.2a
TOP
RETAINER
FRONT
1
4
2
TM
3