Declaration Of Incorporation Of Partly Completed Machinery; Machinery Directive - DITEC VALOR Technical Manual

2. Declaration of incorporation of partly com-
pleted machinery
(Directive 2006/42/EC, Annex II-B)
The manufacturer Entrematic Group AB with headquarters in Lodjursgatan 10, SE-261 44
Landskrona, Sweden
declares that the automation system for Ditec VALOR sliding doors:
- has been constructed to be installed on a manual door to construct a machine pursu-
ant to the Directive 2006/42/EC. The manufacturer of the motorized door shall declare
conformity pursuant to the Directive 2006/42/EC (annex II-A), prior to the machine being
put into service;
- conforms to applicable essential safety requirements indicated in annex I, chapter 1 of
the Directive 2006/42/EC;
- conforms to the Low Voltage Directive 2006/95/EC;
- conforms to the Electromagnetic Compatibility Directive 2004/108/EC;
- technical documentation conforms to Annex VII-B to the Directive 2006/42/EC;
- technical documentation is managed by Marco Pietro Zini with offices in Via Mons. Banfi,
3 - 21042 Caronno Pertusella (VA) - ITALY;
- a copy of technical documentation will be provided to national competent authorities,
following a suitably justified request.
Landskrona, 15-01-2013
2.1

Machinery Directive

Pursuant to Machinery Directive (2006/42/EC) the installer who motorizes a door or gate has
the same obligations as the manufacturer of machinery and as such must:
- prepare the technical file which must contain the documents indicated in Annex V of the
Machinery Directive;
(The technical file must be kept and placed at the disposal of competent national authori-
ties for at least ten years from the date of manufacture of the motorized door);
- draw up the EC Declaration of Conformity in accordance with Annex II-A of the Machinery
Directive and deliver it to the customer;
- affix the EC marking on the motorized door in accordance with point 1.7.3 of Annex I of
the Machinery Directive.
Marco Pietro Zini
(President)
4