Internal Controls - Lincoln Electric 12662 Operator's Manual

MULTIPROCESS WIRE FEEDER WELDER
FIGURE A.3

internal controls

1
6
1. Wire Drive Spindle – Supports a 4-inch or 8-inch spool of
wire. The center wing-nut can be adjusted to increase tension
on the wire. For 4-inch spools, the hub adapter must be
removed.
2. Spool Gun Switch – Permits toggling between standard push
gun welding with the Magnum Pro
welding with the Magnum Pro
3. Wire Drive Tension Pressure Adjustment – Permits
increasing or decreasing the pressure applied to the top drive
roll.
4. Replaceable drive roll - Select the correct drive roll groove
for the wire diameter being fed.
5. Gun Connector Block – Permits securing a welding gun to
the wire drive by ensuring the gun connector is fully seated,
then tightening the knob.
6. Cutouts– A cut out in case back and side allows the input
cord and wire drive polarity lead to be coiled and placed in
the wire drive compartment for ease of transportation.
® 100L or aluminum
®
100SG Spool Gun.
2
3
4
5
6
A-3
INSTALLATION