Stitch Length - Janome CoverPro 1000CP Service Manual

B
(3)
(2)
30 - 32 mm (10 stitches)

10. Stitch Length

The stitch length should be 3.0 - 3.2 mm when the stitch
length dial is set at 3 and differential feed dial at 1.0.
[1] Remove the belt cover.
A
[2] Set the stitch length dial (1) at 3 and differential feed
dial (2) at 1.0.
[3] Place a piece of paper under the presser foot. Lower
the foot and turn the hand wheel toward you about 15
times.
Measure the distance of needle marks of 10 stitches.
The distance should be 30 - 32 mm.
(Use the markings on the Gauge 795G-003 for 30 mm
and 32 mm).
[4] Turn the adjusting screw (3) to adjust the stitch length.
- If the stitch length is longer than 3.2 mm, turn the
(1)
- If the stitch length is shorter than 3.0 mm, turn the
[5] Attach the belt cover.
16
adjusting screw in the direction A.
adjusting screw in the direction B.
30 mm
32 mm