Looper Position - Janome CoverPro 1000CP Service Manual

(2)
(1)

6. Looper Position

The distance between the looper point and center of the
right needle should be 1.8 - 2.2 mm when the looper is at
the right most position.
[1] Remove the free arm cover and needle plate.
(4)
[2] Replace the right needle with the Test Pin 795G-001
(shorter one = 28.8 mm) (1).
[3] Turn the handwheel toward you to bring the looper (2)
to the right most position.
[4] Loosen the setscrew (3) and move the looper to the
left or right to adjust the position.
(3)
NOTES:
Do not move the looper up or down otherwise the looper
height will change.
Use a stem (4) of the regular needle to check if there is a
proper gap between the looper point and Test Pin 795G-
001.
[5] Tighten the setscrew (5) firmly.
[6] Replace the test pin with a regular needle. Attach the
needle plate and free arm cover.
11