Mechanical Adjustment; Presser Bar Height - Janome CoverPro 1000CP Service Manual

Mechanical Adjustment

(2)
(1)
Should be
parallel.
(5)
(1)
(3)
(4)
4.7 - 5.3 mm
Should not interfare

1. Presser Bar Height

The distance between the bottom of the presser foot in up
position and the needle plate should be 4.7 - 5.3 mm.
[1] Remove the face plate and front cover.
[2] Remove the setscrews (1), and lamp set plate (2).
[3] Raise the presser foot and loosen the setscrew (3).
Move the presser bar (4) up or down to set the presser
foot height to 5 mm (Use the third step from the left of
the Gauge 795G-003).
[4] Tighten the setscrew (3) firmly.
NOTE:
Make sure that the presser foot should be parallel to the
feed dog slots (5) in the needle plate and should not
interfere with the needles.
[5] Attach the lamp set plate, front cover and face plate.
5 mm
6