Festool DOMINO User Manual page 79

1
To process the smallest domino (4 x 20 mm), insert the 4 mm
router into the DOMINO DF 500. This router is unique in that
it is shortened by 10 mm. Therefore, at the maximum routing
depth of 20 mm, the routed hole is only 10 mm deep.
3
Set the routing depth to 20 mm, the routing height to the
minimum and the routing angle to 45°.
2
Set the additional stop on the DOMINO DF 500. This uses
the additional stop pins to reduce the lateral distance to the
centre of the DOMINO router from 37 mm to 20 mm.
4
Flip the additional stop pin from the additional stop and place
the joining machine on the workpiece – the routed holes
will be further offset from the edge of the workpiece, which
is beneficial with such narrow workpieces.
4
77