How To Brew Using My Grounds Filter - Mr. Coffee BVMC-SC500 SERIES User Manual

H OW TO B REW U SIN G MY GR OU NDS
1. Place Brewer upright 2. Fill the My Grounds
on a flat surface, reusable filter with 2
remove protective tbsp. of your choice of
sheet and plug into ground coffee. Do not
outlet. exceed the MAX fill line.
NOTE: Make sure the
edge of the filter is free
and clear of any particles
to avoid leaking.
4. Lift and open the top of 6. Push K-Cup
the K-Cup Holder. back into place. The
®
locking tab will snap to
lock it in place.
5. Place My Grounds
TM
reusable filter inside
of K-Cup Holder and
®
close K-Cup Holder
®
Lid.
10
BVMC-SC500 Series_16ESM1.indd 10-11
FILTE R
TM
3. Press lock tab and pull
TM
K-Cup Holder forward.
®
® Holder
CAUTION:
• There are two sharp needles that
puncture the K-Cup ® Pack, one
above the K-Cup ® Pack Holder
and the other at the bottom of
the K-Cup Pack Holder. To
®
avoid risk of injury, do not put
your fingers in the K-Cup Pack
®
Housing Assembly.
• Do not remove K-Cup ® holder
during the brew cycle.
• Do not remove water reservoir
or open the lid during the brew
cycle.
• Do not brew without K-cup ®
Holder in place.
7. Remove water 8. Close reservoir lid and
reservoir and reservoir slide reservoir back
lid, then fill with filtered into place.
or bottled water below
the MAX fill line. Do
not exceed the MAX
fill line.
9. Place a coffee cup or 10. Press the Serving
travel mug (up to 10oz) Size Button to
on the drip tray plate. choose 6 oz or 10 oz.
A light will indicate
your selection.
NOTES:
A. Always brew with
reservoir in place and
with lid closed.
B. For convenience
water reservoir holds
up 24-oz of water to
avoid constant refilling.
Ensure the cup or
mug can hold the
liquid based on the
brew size selected.
C. Any liquid overflow
from your cup will be
collected by the drip
tray to keep brew
space neat and clean.
11. Press Strong Brew to
adjust brew strength
for bold taste if you
like a stronger cup.
11
5/5/16 10:44