Elcometer 415 User Manual page 5

4 GETTING STARTED (continued)
The battery condition is indicated by a symbol in the top right of the
display ( ):
Full symbol (orange) = batteries at full capacity

Empty symbol (red, flashing) = batteries at lowest

sustainable level
4.3 SWITCHING ON / OFF
To switch on: Press and hold the ON/OFF button until the Elcometer
logo is displayed or press the probe against any hard surface and the
gauge will switch on automatically.
To switch off: Press and hold the ON/OFF button until the screen
goes blank.
Note: The gauge will switch off automatically after 1 minute of inactivity.
4.4 SETTING THE BEEP VOLUME
The gauge beeps each time a measurement is taken. To set the beep
volume:
1 Press the '

2 Use the

3 Use the
' ' to disregard any changes made and return to the previous
screen.
4.5 SETTING THE SCREEN BRIGHTNESS
The screen brightness can be set to '
adjusted automatically using the gauge's ambient light sensor - or can
be set by the user to suit the measurement conditions. To set the
screen brightness:
1 Press the '

2 Use the

3 Use the
' ' to set or ' ' to disregard any changes made and return to the
previous screen.
The default setting is ' ' (Auto) .

www.elcometer.com
' softkey.
softkeys to highlight '

softkeys to adjust the volume and press ' ' to set or

' softkey.
softkeys to highlight '

softkeys to adjust the screen brightness and press

' and press ' ' to select.
' (Auto) - the brightness is
' and press ' ' to select.
R
en-4