Martin Audio CCD5 User Manual page 34

CDD
USER GUIDE
The yoke loop (the main, U-shaped part of the assembly) should be fitted to the wall or ceiling
in its intended position. Four 8.5 mm holes are provided for this purpose. It is essential that
appropriate fixings are used to allow safe and secure attachment to the ceiling material,
particularly as these may be fitted overhead public areas. The central 13mm hole can also be
used to mount the yoke which will provide horizontal adjustment as well as vertical; however, a
sufficiently robust fixing method must be used if attaching from this single point and we would
strongly recommend the use of a secondary safety fitting (see note in "Second fix" below). If
not used for fixing, the central hole may be used for cable access. It is also good practice to
terminate the speaker cables with the Phoenix connectors at this stage.
Second fix:
CDD cabinets may only be used with yokes in horizontal ("landscape") mode.
Note that is vital that the driver is orientated to suit the deployment used. "Out of the box"
the driver is in the correct position for "portrait" use and must be rotated through 90° for
"landscape" use. Please see page 12 for details of driver rotation.
First remove two of the M8 screws in the top and bottom of the cabinet. Note that there are
three screws on both top and bottom; the screw nearest the back of the cabinet is not used, so
should be left in place.
The screws removed may be discarded; they should not under any circumstances be used to
secure the yoke as they are of insufficient length for a safe fixing. Only use the longer screws
supplied with the yoke assembly.
CDD User Guide V1.0
34