Martin Audio CCD5 User Manual page 21

CDD
USER GUIDE
The cabinet bracket section must be attached in an orientation to suit the desired degree of
adjustment. First remove the four screws using a 3 mm hex key. For installation with two planes
of adjustment, or vertical adjustment only, the cabinet bracket must be attached as shown
below:
If only horizontal adjustment is required, the bracket section should be fitted like this:
(Note that the two pictures above assume portrait orientation.)
Fix the bracket in place using the screws removed from the cabinet. Tighten these securely.
Remove the pivot bolt from the wall bracket section. Offer the speaker up to the wall bracket
section; if this is in the vertical position as at page 18, the cabinet bracket section or link
bracket will hook securely in place, freeing up both hands for re-fitting the securing bolt:
If the wall bracket is in the horizontal position (allowing only vertical adjustment), simply slide
the two sections of the bracket together and insert the pivot bolt while supporting the speaker
with the other hand. The link section of the bracket assembly is not required for this mounting
option.
CDD User Guide V1.0
21