Camos CWM-500 Instruction Manual page 8

5 Screen switch while trigger input
What is <Trigger input> or <Trigger signal>? We call it when a circuit works by a signal for
example if driver uses right/left turn signal or reverse gear, the monitor shows connected
camera screen on driving mode.
* Below example is set with TRG1(Left signal light)=CAM1 / TRG2(Right signal light)=CAM2 /
TRG3(Rear light)=CAM3.
1) If there is trigger signal input, the connected screen (Trigger input screen) is displayed and
the screen goes former one when the signal is disappeared.
ex. CAM3(Rear view)
2) In case of light on emergency blinker(TRG1+TRG2), the monitor displays CAM3. And the
screen goes former one when the signal(light on emergency blinker) is disappeared.
ex. CAM1(Left view)
The example is set with TRG1(Left signal light=CAM1 / TRG2(Right signal
light)=CAM2 / TRG3(Rear light)=CAM3.
NOTICE
8
CAM3
Current screen
CAM1
Current screen
CAM1
Connected screen
by the trigger line
CAM3
Rear view camera screen(CAM3)
with the emergency light