Troubleshooting - Sony STR-DN1080 Operating Instructions Manual

Multi channel av receiver
Hide thumbs Also See for STR-DN1080:
Table of Contents

Advertisement

5
Update the software.
"UPDATING" flashes on the display panel
during the software update process.
However, "UPDATING" may disappear
temporary during updating.
When the update is completed,
"COMPLETE" appears on the display
panel and the receiver restarts
automatically.
Note
It may take about 1 hour for the update to be
completed.
You cannot restore the old version after updating
the software.
Set [Auto Update] to [On] when you want to
perform software updates automatically.
Depending on the contents of the updates,
software update may be performed even if you set
[Auto Update] to [Off].
GB
52

Troubleshooting

If a problem occurs while operating the
receiver, check the following to resolve the
problem before consulting your nearest Sony
dealer.
Check to see if the problem is listed in this
"Troubleshooting" section.
Visit the Help Guide for detailed examples.
You can search by a keyword using the
online troubleshooting guide.
http://rd1.sony.net/help/ha/strdn108/
h_eu/
If the problem persists after doing all of the
above, consult your nearest Sony dealer.
General
The receiver is turned off automatically.
If [Auto Standby] is set to [On], set it to [Off].
The sleep timer function was activated.
"PROTECTOR" was activated.
The indicator on the display panel turns off.
If the PURE DIRECT indicator on the front
panel lights up, press PURE DIRECT to turn
off this function.
Press DIMMER on the receiver to adjust the
brightness of the display panel.
Video
No image appears on the TV screen.
Try pressing the input button on the remote
control or turning INPUT SELECTOR on the
receiver to select the input to which you
want to listen.
Set your TV to the appropriate input mode.
Move your audio device away from the TV.
Make sure that cables are correctly and
securely connected to devices.
Disconnect the HDMI cable from the
receiver and TV and then reconnect the
cable.
Set [HDMI Signal Format] of the selected
input to [Standard format] in the [HDMI
Settings] menu.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents