Sony STR-DN1080 Operating Instructions Manual page 50

4
Press / to select the name of
the headphones/speakers,
and then press
After "CONNECTING" flashes and the
headphone name or speaker name is
displayed, the BLUETOOTH connection is
complete.
CONNECTING
XXXXXX
* "XXXXXX" represents the name of a detected
BLUETOOTH device.
5
Press one of the input buttons
to select the input you want.
The sound is output from the
BLUETOOTH headphones/speakers. No
sound is output from the receiver.
6
Adjust the volume of the
BLUETOOTH headphones/
speakers.
Volume control on the receiver and
remote control only works for the
BLUETOOTH headphones/speakers.
Note

The most recently connected BLUETOOTH device
can be reconnected simply by performing step 1
above.

The one-touch connection (NFC) cannot be used in
TX (transmitter) mode.

When "NOT. USE" appears on the display panel,
you cannot switch BLUETOOTH mode. Check the
following:
 BLUETOOTH function is in use
 [Bluetooth Mode] is set to [Off]
GB
50
.
*
Tip
You can also switch the BLUETOOTH mode to TX
(transmitter) mode by setting [Bluetooth Mode] to
[Transmitter] in [Bluetooth Settings]. Then select the
name of the headphones or speakers from [Device
List] in [Bluetooth Settings]. If you cannot find your
device name in the list, select [Scan].