Using Netware; Setting Up As A Print Server (Netware 3.X) - Ricoh AFICIO SP C430DN Operating Instructions Manual

Using NetWare

This section describes the setting procedure for network printers in the NetWare environment. In the
NetWare environment, you can connect the printer as a "print server" or "remote printer".
• IPv6 cannot be used on this function.
Setting procedure
• When using the printer as a print server
1. Install the network interface board.
2. Turn the printer off and then back on.
• When using the printer as a remote printer
1. Install the network interface board.
2. Configure NetWare.
3. Start the print server.
• This procedure assumes an environment is already prepared for normal NetWare running
the printing service setting.
• The procedure is explained with the following example settings:
• File server name ...CAREE
• Print server name ...PSERV
• Printer name ...R-PRN
• Queue name ...R-QUEUE

Setting Up as a Print Server (NetWare 3.x)

Follow the procedure below to connect the printer as a print server using NetWare 3.x.
1. Start Web Image Monitor.
2. Click [Login].
A dialog box for entering the login user name and password appears.
3. Enter the login user name and password, and then click [Login].
For details about the login name and password, consult your network administrator.
4. Click [Configuration] in the left area, and then click [NetWare Print Settings].
• Print Server Name: Enter the NetWare print server name. To use the interface board as a print
server, enter the name of a print server that is not active on the file server. Use up to 47 characters.
Using NetWare
7
177