Typical Installation - Kinetico Essential 8 Installation And User Manual

Typical installation

Your installation may vary.
1. A non-return valve (included in the Kinetico by-pass set) is required on the mains
water supply to the softener.
2. Fit a pressure regulating valve, if required, on the mains water supply to the softener.
3. Plumb a drain line from the softener to a waste pipe through an appropriate air gap
compliant with water regulations.
4. Consult WRAS Information and Guidance Note, no. 9-07-01 for regulatory advice.
Figure 1:
For illustration purposes only.
Note: Air gap waste fitting contains a water trap.
Essential 8 and 11 Water Softener | Installation and User Manual
07