Typical Installation - Kinetico 2020C Installation Instructions Manual

2020c water softener
Installation Instructions
safety Information
Read all steps, guides and rules carefully before installing and using the Kinetico softener.
Check your local building and sanitation codes for installation compliance.
adhere to all by laws including, but not limited to:
• Kinetico recommends that a qualified installer or engineer performs the installation.
Failure to install the system as instructed could invalidate the warranty.
• Do not install if the supply water pressure exceeds 125 psi (8.3 BAR).
Unless a suitable regularity pressure valve has been installed on the water supply to the
softener, the water temperature must not exceed 120°F (48.8°C).
• Do not install the Kinetico softener in an area where the temperature can cause the unit
to freeze. Freezing temperatures will damage the system.
Very important!
Where a cabinet overflow could cause damage, you must install a 1/2" (12mm) I.D. overflow
line on the barbed fitting on the cabinet and run to a suitable outlet that is visible and
capable of taking the overflow (ie. through the outside wall). Make sure the outlet is not
higher than the barbed fitting.
• When installing a plastic component on a copper pipe in line, Kinetico recommends
placing earth continuity straps ACROSS the component being fitted to ensure that the
earth continuity is never broken.
• A Kinetico installation kit includes a manually operated by-pass device which enables the
softener to be isolated from the water service lines for maintenance and service. This
also maintains the continuity of the water supply when the system is disconnected.
• These systems are not intended to be used for treating water that is microbiologically
unsafe or water that has an unknown quality without adequate disinfection before or
after the system.
Important: refer to the plumbing schematic in figure 1 before beginning installation.
note: There are two 2020c compact water softener models. The High Efficiency (HE)
system (part no. 11694uk) is designed for, but not limited to, most applications with general
flow rate requirements.
The High Flow (HF) system (part no. 11717uk) is designed for homes requiring higher flow.
If you are unsure which system is best for your application, contact Kinetico for advice.
For more information about Kinetico -
visit www.kinetico.co.uk or freephone 0800 015 1380
Kinetico UK Ltd
Bridge House, Park Gate Business Centre, Park Gate, Hampshire SO31 1FQ
02
From
Mains Supply
visit www.kinetico.co.uk

tYPICaL InstaLLatIon

A typical Kinetico 2020c Installation shown
with Kinetico reverse osmosis drinking
water systems.
Your installation may vary.
figure 1
Bypass
Inlet
To
Drain
1. A non-return valve is required on the water main supply to the softener. This may be
incorporated in your Kinetico installation kit.
2. Fit a pressure regulating valve, if required, on the water supply to the softener.
3. Plumb the drain line from the softener to a waste pipe through an appropriate air gap.
freephone 0800 0151 380
2020c water softener
Installation Instructions
To Home
To Reverse Osmosis
drinking system
Outlet
Overflow
03