Casio PX-780 Service Manual page 38

8-2. To boot the diagnostic program
1. Insert the card with the Service Utility Programs in Section 8-1 to IT-3100.
2. Perform full reset.
3. Perform set up according to the instructions in the display.
• Touch Screen Calibration
• Data/Time Properties
• Owner Properties
4. Open the storage card folder, and double-tap "DIAG780".
My Computer g Storage Card g DIAG780
5. Tap the center of the display. g The diagnostic program menu appears.
Menu
Main Menu 1 appears when the diagnostic program is booted.
There are three menu types in the Main Menu, which can be switched from one to another by the following
operation.
Press [ENT].
Tap [NEXT] in the display.
Tap [BACK] in the display.
** Main menu 1 **
1.SDRAM
2.NAND-FROM
3.KEY/BUTTON
4.TOUCH PANEL
5.LCD
6.LED
7.Sensor
8.Speaker
9.PCMCIA Card
0.SD Card
[BACK]
Ending the diagnostic program
Perform the following operation to end the diagnostic program.
Tap "0. Quit" in the Main Menu 2 or Main Menu 3.
Tap [NEXT]
or
press [ENT]
Tap [BACK]
[NEXT]
** Main menu 2 **
1.ASK/IrDA
2.2D_Scanner
3.Printer
4.MCR
5.Serial 8P
6.Serial 14P
7.Battery Life
8.Key BackLight
9.
0.Quit
[BACK] [NEXT]
Tap [BACK]
Tap [NEXT] or press [ENT].
– 36 –
** Main menu 3 **
Tap [NEXT]
1.Power Block
or
2.Dummy Load
press [ENT]
3.Load Run
4.Battery Life
5.Aging
6.Key Status
7.Initial Data (IP Address)
8.2D_Scanner
9.Printer
0.Quit
Tap [BACK]
[BACK] [NEXT]