Basic Operations - Casio PX-780 Service Manual

Handheld terminal
Table of Contents

Advertisement

6. BASIC OPERATIONS

6-1. Attaching the Neck Strap
A neck strap can be attached to the Handheld Printer Terminal to keep it from being dropped while being
carried. The stylus holder provided can also be attached.
Neck strap rings*
Mounting
hooks
Attach the neck strap following the procedure described below.
Attachment Procedure
1. Pull out the neck strap mounting hooks out of each silo on the bottom
of the Handheld Printer Terminal using the tip of stylus. Hook the
protrusive part (**) of the ring on the neck strap mounting hook as
shown in the illustration. While slightly pushing the ring, turn the ring
until all part of it is fully hooked.
** The ring is very stiff for the first time. A small flat screw driver is
helpful by inserting it into overlapped part of the ring to make a room
when hooking the protrusive part.
2. Pull back the locking bar of the neck strap mounting hook and then
hook the mounting hook onto the ring as shown in the illustration.
Removal Procedure
1. Pull back the locking bar of the neck strap mounting hook and then
release the hook from each ring as shown in the illustration.
2. Following the attachment procedure in reverse way, remove the neck
strap rings from each neck strap mounting hook on the Handheld
Printer Terminal and then push back the neck strap mounting hooks
into each silo.
Adjust length here
Neck strap
* ; The rings give an extra mechanical strength for
the Neck Strap. The metallic hooks of the Neck
Strap can, in rare case, be worn by abrasion
induced by swinging the IT-3100 terminal
specifically when it is hung from the operator's
neck with the Neck Strap. For those who often
use the IT-3100 terminal in a hanging position, it
is recommended to use the rings to secure the
Neck Strap.
– 25 –
Stylus holder
The illustration shows the IT-3100M53E.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

It-3100 series

Table of Contents