Electronic Device Connections And Functions - Jacuzzi J-315 Installation Manual And Use & Maintenance

Stereo Setting
Press the Audio button 9 times to access the Stereo setting. The
LCD display will change to "STEREO, " . Press the Up button to
select either Stereo or Mono.
Wireless Remote Control Functions
A wireless radio frequency (RF) remote control is supplied on
all spas with the optional audio system. This remote provides con-
trol of the radio and over some media device functions.
External Media Device Playback
The supplied remote control provides no control over external
Auxiliary player operations except for volume control and source
selection. The Auxiliary player performs all external playback
operations.
AUDIO
1
DIR -
Power Button: Press once to turn ON; Press again to
turn OFF.
Audio Button: Allows access to most of the stereo
AUDIO
sound functions. Press continuously to scroll through the
following settings: Bas-Tre- Bal-Fad-DSP-Area-Loud-DX-
Stereo.
Mode Button: Press continuously to switch between "RA-
MODE
DIO, " "USB, " and "AUX IN" modes. "BT CONNECTED" ap-
pears when a Bluetooth device in paired with the stereo.
Volume Up Button: Used to increase volume between
0 to 30.
Volume Down Button: Used to decrease volume be-
tween 30 to 0.
USB Mode: Press to pause track, press again to resume
playing (Device Mode USB)
Mute Button: Press to mute sound, press again to re-
activate sound (Radio Mode)
Track Down Button: Press to rewind tracks (Device
Mode USB)
Seek Button: Seeks down for stations (Radio Mode)
Track Up Button: Press to move forward tracks
(Device Mode USB)
Seek Forward Button: Seeks forward for stations
(Radio Mode)
MODE
2 3
DIR + REPEAT RANDOM
Press either of these buttons to change music folders
1
(Device Mode USB)
Preset 1: Press to access a preset station (Radio Mode)
Preset 2: Press to access a preset station (Radio Mode)
2
Press once to repeat the song. Press again to repeat the
3
album (Device Mode USB)
Preset 3: Press to access a preset station (Radio Mode)
Press to play songs in a random order (Device Mode USB)
Not used (Radio Mode)

Electronic Device Connections and Functions

CAUTION: RISK OF ELECTRICAL SHOCK OR E-
QUIPMENT DAMAGE! Never install, remove or operate
any electrical device (e.g. iPod/MP3/USB/AUX/Bluetooth)
while hands are wet or while sitting partially or fully im-
mersed in the spa!
Operating the Radio:
Turn power ON to the stereo unit and remote.
The LCD screen on the remote will display the following: "Wel-
come, " "Load, " "Radio" and the station number.
You can use the seek button to search for frequencies. You can
save up to 3 stations as presets.
Follow the steps below to set a station:
a. Find a station you want to save.
b. Press and hold one of the three preset buttons. The station
number on the display will quickly flash to confirm the setting.
To set the additional two stations, conduct this step again.
Connecting Your iPod®/MP3 Player Using the USB:
- Turn power OFF to the stereo unit.
- Locate the USB port in the stereo locker.
- Locate the 30-pin cable provided for compatible devices or a
cable provided with your device.
- Connect the USB end of the cable into the USB connection
on stereo.
- Connect the 30-pin end of the cable to the iPod/MP3 Player
(purchased separately).
- After connecting the cable to both devices, set the player in-
to the rubber holding base.
USB USB
AUX AUX
35
USB
AUX