Mounting The Access Point On A Vertical Or Horizontal Surface - Cisco 15454-GBIC-LX= - 1000 Mbps GBIC Expansion Slot Hardware Installation Manual

Chapter 2 Mounting Instructions

Mounting the Access Point on a Vertical or Horizontal Surface

To mount the access point on a vertical or horizontal surface such as a wall or a roof-overhang, use the
supplied mounting plate. For the correct access point mounting orientations, refer to the
Mounting Orientations" section on page
The mounting plate is attached to the access point by two carriage bolts. Refer to
Step 1
location of the carriage bolts securing the mounting plate.
Figure 2-6
1
1
2
Step 2 Remove the nuts and washers from the carriage bolts and remove the carriage bolts.
Remove the mounting plate from the access point.
Step 3
OL-9977-05
C i s c o C o n f i d e n t i a l - D r a f t 1
Access Point Mounting Plate and Carriage Bolts
Mounting plate
Carriage bolts
Cisco Aironet 1500 Series Outdoor Mesh Access Point Hardware Installation Guide
2-12.
2
2
3
3 Grounding screw hole
Mounting the Access Point
"Access Point
Figure 2-6 for the
2-15