Table of Contents
Advertisement
Refer to the Analyst
modify parameters. During the PreDive Prediction
Mode, the unit will compute and display the maximum
safe time and the calculated PO
TOUCH PROGRAMMING INFORMATION DISPLAY:
The Information display is accessed via the
Programming Mode. The information presented will
appear as in Figure 24. The information in the upper
right of the screen indicates the unit is in the Air Only
FO2 Mode.
Identifier
F0
The Battery voltage is displayed in the lower center of
the screen as a two-digit number with a decimal point
proceeded by a lower case 'b'. Figure 24 shows what
the display screen looks like for a Commander
configured for Air Only.
TOUCH PROGRAMMING - DEPTH ALARM: The
Depth Alarm allows the diver to select a maximum
depth below which the diver does not wish to descend
before an alarm is issued. This depth can be set from
0 to 320 feet in one foot increments.
®
for information about how to
Description
Air only
1 6
value at that depth.
2
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the COMMANDER and is the answer not in the manual?
Questions and answers
My Cochran dive watch is not giving me actual depth measurements. I’m diving at altitude and the dive depths are incorrect.How do I rest it?
The Cochran COMMANDER dive watch adapts to altitude automatically as part of its environmental adaptation features. There is no specific manual reset required. However, if depth measurements appear incorrect, ensure the unit is functioning properly by installing fresh batteries and verifying its settings via the Analyst® P.C. Interface. If issues persist, contact Cochran Customer Support.
This answer is automatically generated