Switching Bluetooth On And Off; Resetting The Cleaning Indicator; X-Fcm Grating Fastener; X-Fcp Checker Plate Fastener - Hilti DX 5 Operating Instructions Manual

2. Pull the fastener out of the tool.

5.6 Switching Bluetooth on and off

▶ Press and hold the pushbutton for 1-2 seconds to switch on Bluetooth.
Note
Bluetooth switches itself off automatically after 2 minutes.

5.7 Resetting the cleaning indicator

▶ Press and hold the pushbutton for 10-12 seconds to reset the cleaning indicator.
Note
The cleaning indicator consists of 5 bars. Each bar stands for 500 fastenings.

5.8 X-FCM grating fastener

1. Position the grating.
2. Drive the threaded stud into the steel beam. Use the centering sleeve to help ensure easy centering of
the fastener. Measure the stud stand-off distance by checking the depth of penetration with the gauge.
3. Screw on the retaining flange.
◁ Torque: 5-8 Nm

5.9 X-FCP checker plate fastener

1. Drill or punch the holes in the checker plate.
Note
Observe the following minimum dimensions and distances:
A = 18-20 mm (0.70''-0.7'')
B ≥ 25 mm (≥ 0.98'')
2. Position the checker plate.
3. Drive the threaded stud through the predrilled or punched hole. Measure the stud stand-off distance by
checking the depth of penetration with the gauge.
4. Screw on the retaining flange.
◁ Torque: 5-8 Nm
5.10 Driving X-GR grating fasteners
1. Insert the fastener in the base plate.
2. Drive the fastener through the grating into the supporting steel.
3. Tighten the fastener securely.
◁ Torque: 3-5 Nm
4. Screw on the retaining flange.
◁ Torque: 5-8 Nm
5.11 Procedure if a cartridge fails to fire
1. Keep the nose of the tool pressed at right angles against the working surface for 30 seconds.
2. If the cartridge still fails to fire, lift the tool away from the working surface. Take care to avoid pointing it
at yourself or other persons.
3. Pull the cartridge strip by hand to advance it to the next cartridge and use up the remaining cartridges
on the strip.
5.12 Tool misfires (cartridge doesn't fire)
WARNING
Heat The tool can get hot through use.
▶ Wear protective gloves.
▶ Allow the tool to cool down.
6
10
11
12