Axis 211 Quick Start Manual page 7

A3090-1.1 en
Symbols pointing out notes on use and waste disposal as well as useful information:
NOTE
Points out that important information about the product or its handling is being given.
Meaning: CE mark
The CE mark enables the manufacture to guarantee that the product complies with the
requirements of the relevant CE directives (the declaration of conformity is available at
http://www.hbm.com/HBMdoc).
Meaning: Statutory marking requirements for waste disposal
National and local regulations regarding the protection of the environment and
recycling of raw materials require old equipment to be separated from regular
domestic waste for disposal.
For more detailed information on disposal, please contact local authorities or the
dealer from whom you purchased the product.
Working safely
Error messages may only be acknowledged if the cause for the error has been
removed and no further danger exists.
Conversions and modifications
HBM's express consent is required for modifications affecting the Axis 211 Network
Camera design and safety. HBM does not take responsibility for damage resulting
from unauthorized modifications.
In particular, any repair or soldering work on motherboards is prohibited. When
exchanging complete assemblies, it is essential to use original HBM parts only.
The product is delivered from the factory with a fixed hardware and software
configuration. Changes can only be made within the possibilities documented in the
manuals.
Qualified personnel
The equipment may be used by qualified personnel only; the specifications and the
special safety regulations need to be followed in all cases.
This means people who meet at least one of the three following requirements:
• Knowledge of the safety concepts of automation technology is a requirement
and as project personnel, you must be familiar with these concepts.
• As automation plant operating personnel, you have been instructed how to
handle the machinery and are familiar with the operation of the equipment and
technologies described in this documentation.
• As commissioning engineers or service engineers, you have successfully
completed the training to qualify you to repair the automation systems. You are
also authorized to activate, to ground and label circuits and equipment in
accordance with safety engineering standards.
It is also essential to comply with the appropriate legal and safety regulations for the
application concerned during use. The same applies to the use of accessories.
The term "qualified personnel" refers to staff familiar with the installation, fitting,
start-up and operation of the product, and trained according to their job.
Network Camera Devices
7