Download  Print this page

Axis 210 Quick Installation Manual

Hide thumbs

Advertisement

4XIS
A
C O M M U N I C A T I O N S
AXIS 210/211 Network
Camera
Contents
AXIS 210/211 Network Camera Quick Installation Guide ............................................ 3

Advertisement

Table of Contents
loading

  Related Manuals for Axis 210

  Summary of Contents for Axis 210

  • Page 1 4XIS C O M M U N I C A T I O N S AXIS 210/211 Network Camera Contents AXIS 210/211 Network Camera Quick Installation Guide ..........3...
  • Page 2: Package Contents

    AXIS 210/211 Network Camera Quick Installation Guide Follow these steps to install the AXIS 210/211 on your local network (LAN): 1. Familiarize yourself with the AXIS 210/211 Network Camera (this page). 2. Connect the camera - see Cable Connections, on page 4.
  • Page 3: Cable Connections

    Important! The AXIS 210 is designed for indoor use only, and must always be positioned where it is not exposed to direct sunlight or strong halogen light, which can cause permanent damage to the camera's image sensor.
  • Page 4: One-Click Installation

    • To remove the DNS name and unregister from the Axis Internet Dynamic DNS Service, open the Setup pages in the AXIS 210/211, click System Options > Network > TCP/IP, click the Settings button for the AXIS Internet Dynamic DNS Service and finally, click the Remove button.
  • Page 5: Axis Ip Utility

    Click the button "Set IP address using serial number" and enter the serial number (see page 3) and IP address for the AXIS 210/211. Follow the on-screen instructions. Note: After using the AXIS IP Utility, the One-click installation method can be used to obtain a DNS name for the AXIS 210/211.
  • Page 6: Manual Installation With Arp/Ping

    Manual Installation with ARP/Ping 1. Acquire an unused IP address for the AXIS 210/211. This IP address must be on the same subnet as your computer. 2. Locate the serial number (S/N) on the camera's underside label. 3. From a computer on your network, open a Command Prompt (in Windows: from the Start menu, select Run...
  • Page 7: Resetting To The Factory Default Settings

    Accessing the AXIS 210/211 from the Internet Once installed, your AXIS 210/211 is accessible on your local network (LAN). To access the camera from the Internet you must configure your broadband router to allow incoming data traffic. For security reasons this is usually done on a specific port.

This manual is also suitable for:

211