Operation; Setting - Rextron NXMU-M220 User Manual

III. Operation
The LEDs on the Extender Units show the real-time status indicating the linking and
communication between the Sender Unit and the Receiver Unit. Users can identify the
current status through the LED indicators on the unit.
The quality of the output signal will depend largely upon the quality of video source,
cable and display device used. Low quality cables degrade output signal causing
elevated noise levels. Please use the proper cable and make sure the display device is
capable of handling the resolution and refresh rate selected.
NOTE:
The system will disable the video output signal when it detects non-HDCP compliant
display(s) on playing the HDCP video source. All the connected output displays MUST
be HDCP compliant, when the video source is HDCP compliant.

1. Setting

User needs to do the first thing setting Unicast mode in the browser because factory
default is Multicast Mode.
1.1 How to set Unicast for Sender
A). Domain Name
The first thing users need to do is setting the unit as Uni-cast mode via
browser because the factory default setting is Multi-cast mode. Identical ID
setting on the rotary DIP switch of both Sender and Receiver is essential.
Open web browser and insert the address. Please see the "Network
Configuration" section.
B). IP
Open web browser and insert Sender's IP address. If you don't know IP
address, you could find on the corner of Host Selection. Please see the
"Network Configuration" section.
C). Serial Command
1.2 How to set Unicast for Receiver
A). IP
Open web browser and insert Receiver's IP address. If you don't know IP
address, you could find on the corner of Host Selection. Please see the
"Network Configuration" section.
B). Serial Command
For more detail, please follow Network Configuration.
Part 1: Uni-Cast Configuration
8