2. Push Button Control
Press once (click within 0.3 sec.) - Link/ Unlink video (also functions for
all Tx & Rx in the same channel)
F1
Factory Default Setting for Tx: Power off the unit → Press and hold the
button → Power on the unit → Release the button after 17 sec. right
after the Power/Link LED flashes green & blue) → Re-power the unit
Press for 1 sec. - Select Graphic Mode or Video Mode (also functions for
Tx
all Tx & Rx in the same channel)
(Factory default: Graphic Mode)
F2
Press for 3 sec. – Enter Anti-Dither Adjustment Mode: Level 1 /Level 2 /
Off (also functions for all Tx & Rx in the same channel)
(Factory Default: Off)
Reset Reboot the system
Press once (click within 0.3 sec.) - Link/ Unlink video (also functions for
all Tx & Rx in the same channel)
Press and hold – USB port function enable/ disable
F1
Factory Default Setting for Rx: Power off the unit → Press and hold the
button → Power on the unit → Release the button after 17 sec. right
after the Power/Link LED flashes red & blue) → Re-power the unit
Press for 1 sec. - Select Graphic Mode or Video Mode (also functions for
all Tx & Rx in the same channel)
Rx
(Factory default: Graphic Mode)
Press for 3 sec. – Enter Anti-Dither Adjustment Mode: Level 1 /Level 2 /
Off (also functions for all Tx & Rx in the same channel)
F2
(Factory Default: Off)
*EDID Copy: Power off the unit → Press and hold the button → Power
on the unit → Release the button after 12 sec. (the Network Status LED
flashes yellow)
Reset Reboot the system
VIDEO Extender over Giga LAN
9
Part 1: Uni-Cast Configuration