Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Rextron EV214
Summary of Contents for Rextron EV214
- Page 2 Copyright 01/2004 Rextron Technology, Inc. PP5-V3000-000 Printed in Taiwan...
-
Page 3: Table Of Contents
Table of Content ■ Introduction..............1 ■ Product Description VGA CAT5 Extender Pair ..........2 VGA + Audio CAT5 Extender Pair ........3 ■ CAT5 Cable ..............4 ■ Installation VGA CAT5 Extender Pair ..........6 VGA + Audio CAT5 Extender Pair ........7 ■... -
Page 4: Introduction
----------------- Introduction The “VGA CAT5 Extender” pair enables you to transmit VGA signals up to 150M (500 ft.) away with resolution up to 1024 x 768. Featuring common mode noise suppression circuit for superb VGA quality via inexpensive unshielded twisted pair CAT5 cables. The Local unit duplicates the input signal for local use and transmits the VGA signal to a Remote unit. -
Page 5: Product Description
----------------- Product Description VGA CAT5 Extender Pair... -
Page 6: Vga + Audio Cat5 Extender Pair
VGA + Audio CAT5 Extender Pair... -
Page 7: Cat5 Cable
----------------- CAT5 Cable The Extender Pair requires a piece of UTP (Unshielded Twisted Pair) CAT5 cables no longer than 150 meters (490 feet). The cable must be wired according to the EIA/TIA 568B industry standard as shown below. Pin Wire Color Pair Function 1 White/Orange... - Page 8 The above diagram shows the RJ45 connector of a CAT5 cable with its metal contacts facing up.
-
Page 9: Installation
----------------- Installation VGA CAT5 Extender Pair The figure indicates the complete connection. Note: Not all devices shown below are required for the pair to operate. CAT5 cable, VGA source and power supplies are required. -
Page 10: Vga + Audio Cat5 Extender Pair
VGA + Audio CAT5 Extender Pair Note: The pair can be used for either audio or VGA signal or both. - Page 11 The "VGA + Audio CAT5 Extender" accepts one stereo signal (the left and the right channels) input on an audio jack (similar to a computer). This stereo signal is broadcasted to the two local audio outputs and is "mixed" together to form a mono signal before transmitting to a Remote unit via CAT5 cable.
-
Page 12: Operation
----------------- Operation There are two LEDs on the Local unit. The POWER LED must illuminate indicating the unit is properly powered. The ACTIVE LED illuminates when there is VGA input signals. Likewise, the POWER LED of the Remote unit illuminates indicating the unit is properly powered. -
Page 13: Specifications
----------------- Appendices Specifications EV214 CAT5 Extender EV12L EV02R Local unit for Remote unit for Purpose VGA source VGA extension Extension output Extension input RJ-45, CAT5 connector for VGA for VGA Cable between units CAT5, CAT5e and CAT6 Max. distance 150 meters*... -
Page 14: Troubleshooting
----------------- Troubleshooting Symptom Solution No VGA signals at the Remote unit. . Both units must be powered . ACTIVE LED on the Local unit and the Remote unit must illuminate indicating the signal is correct. VGA signal is garbled Make sure the wires are correctly wired inside the cable according to EIA568A or EIA568B standard. -
Page 15: Limited Warranty
Limited Warranty IN NO EVENT SHALL THE DIRECT VENDOR'S LIABILITY FOR DIRECT OR INDIRECT, SPECIAL, INCIDENTIAL OR CONSEQUENTIAL DAMAGES, LOSS OF PROFIT, LOSS OF BUSINESS, OR FINANCIAL LOSS WHICH MAY BE CAUSED BY THE USE OF THE PRODUCT EXCEEDS THE PRICE PAID FOR THE PDOCUDT., The direct vendor makes no warranty or representation, expressed or implied with respect to the contents or use of this documentation, and especially disclaims its quality, performance, merchantability, or fitness for any particular...