Subaru LEGACY 2002 Quick Reference Index page 592

Instrumentation/Driver Info
If everything is normal, the telltales should be ON, OFF or in other states as shown below accord-
ing to ignition switch positions.
Telltale light
(1) FWD
(2) LO
(3) VDC OFF
(4) VDC operation
(5) Turn signal
(6) Door or rear gate
open
(7) Seat belt
(8) Headlight beam
(9) HOLD
(10) AT selector lever position
(11) Immobilizer
(12) POWER
(13) Low fuel
(14) Lighting switch
*1:This light illuminates when quantity of the fuel remaining in the tank has decreased to 10 liters (2.6 US gal, 2.2 Imp gal) or smaller.
*2:This light illuminates when the AT is in the HOLD mode.
*3:This light stays illuminated for about 6 seconds after the ignition switch has been turned ON.
*4:This light illuminates when the AT is in the POWER mode.
*5:This light blinks when the ignition key has been removed from the ignition switch, or when 60 seconds or more time has passed
after the ignition key was inserted in the ignition switch and was turned to the LOCK or ACC position.
*6:This light stays ON for about 2 seconds, and then goes out.
*7:This light illuminates when the lighting switch is turned to the first position.
*8:This light stays ON for about 4 seconds, and then goes out.
COMBINATION METER
LOCK/ACC
! FWD OFF
! AWD OFF
Low range OFF
!
! High range OFF
OFF
OFF
OFF
! Open ON
Shut OFF
!
OFF
! High beam OFF
! Low beam OFF
OFF
OFF
*5
OFF
OFF
OFF
Ignition switch position
ON
ON
OFF
ON
OFF
ON
*6
Blink
ON
OFF
*3
ON
OFF
*2
ON
OFF
ON
*1
*7
IDI-8
ST While engine is
running
ON ON
OFF OFF
ON ON
OFF OFF
ON *8
ON OFF
Blink Blink
ON ON
OFF OFF
*3 *3
ON ON
OFF OFF
*2 *2
ON ON
OFF OFF
*4 *4
*1 *1
*7 *7