Samsung NX58H9500WS/AA Service Manual page 71

SYMPTOM
* There is no electrical power to the
range.
* The gas supply valve to the range is
closed.
* Check the terminals on the spark
None of the
module for voltage.
cooktop burners
* Check for crimped or broken gas line
will light.
between the pressure gas regulator
and the surface burner control
manifold.
* Gas pressure regulator switch is
closed.
* Check the harness connections at
the spark module.
* Check the spark module.
* Check the electrode for that burner.
One cooktop
burner does not
light.
* Check for a dirty surface burner
* Check for crimped or broken gas
lines.
* Faulty surface burner control
* Check for crimped gas line between
the pressure gas regulator and the
All surface
surface burner control manifold.
burners will light,
but don't stay lit.
* Faulty gas pressure regulator.
* Check for a dirty surface burner
One cooktop
burner lights, but * Check for a crimped gas line.
doesn't stay lit.
* Faulty surface burner control.
DIAGNOSIS
71
REMEDY
* Plug in the power cord and/or reset the
circuit breaker for the range.
* Open the gas supply valve.
* Replace the faulty spark module.
* Replace the damaged gas line.
* Replace the gas pressure regulator.
* Reconnect loose conection or replace
damaged harness.
* Disconnect the spark module terminal for
the nonworking burner. If no voltage is
measured, replace the spark module.
* Disconnect the electrode and check whether
electrode wire or tip is broken. Replace the
faulty electrode.
* Clean and/or replace the surface burner
NOTE:
always be the same size as removed.
* Replace damaged gas lines.
* Each surface burner control is an integral
part of the surface burner control manifold.
Replace the manifold.
* Replace the damaged gas line.
* Replace the gas pressure regulator.
* Clean and/or replace the surface burner
NOTE:
always be the same size as removed.
* Replace the crimped gas line.
* Each surface burner control is an integral
part of the surface burner control manifold.
Replace the manifold.