Maintenance - Endress+Hauser Flowphant T DTT31 Operating Instructions Manual

DTT31, DTT35

Maintenance

5.2.2 Hints for the configuration with ReadWin 2000
Comprehensive information on the ReadWin 2000 configuration software may be found in the
Operating Instructions BA137R/09/en.
5.2.3 Hints for the configuration with FieldCare
FieldCare is an universal configuration software based on FDT/DTM technology.
NOTICE
To configure the Flowphant T DTT31/35 with FieldCare the "PCP (ReadWin) Communication
DTM" and the Flowphant Device-DTM are required.
The device supports only offline configuration and up-/download of parameters. The online
configuration is not supported.
Detailed information concerning FieldCare may be found in the operation manual (BA027S/c4)
or see: www.endress.com.
6 Maintenance
Any buildup on the sensor can have a negative effect on the accuracy. For this reason, check the
sensor for buildup at regular intervals.
CAUTION
!
Make sure the process is unpressurized before you remove the device! Do not twist the device
out of the process connection thread at the housing. Always use a suitable open-ended wrench
for disassembly work (see also → Fig. 5) (→ Chap. 3.3.1).
27
Endress+Hauser